|
OUR TECHJET 3000
Waterjet machining is the fastest and most economical way to cut odd shapes (especially in large quantities) from virtually
any material. While not quite as accurate as machining, our CNC waterjet is capable of holding +/- .005 on smaller
parts and +/- .010 over the entire 60" x 120" cutting area. However, for dimensions or surface requiring tight
tolerances or nice machined finishes, the waterjet is a superior machine for roughing out parts that would take 5 or even
10 times longer to just machine from scratch.
Waterjet machining uses a combination of an abrasive (usually garnet) and high pressure water to cut with. Our
Techjet 3000 cuts at 55,000 psi which allows us to cut almost any material and up to 6 inches thick (depending on material
being cut).
|
